DC 12-110V 5A PWM Motor Speed Controller, AC 12-110V DC 15-160V Directly Input Electric Motor Control Module 300W for MACH3 Motor,Pumps, Fans

Descriptions: This motor speed controller can support AC and DC input. Non-existent power supply polarity problems.Large heat sink with mounting holes. and with a wide range of support motor. It can be used to control most of the DC motor in the market Features: Can support AC and DC input. Non-existent power supply polarity problems. Ultra-high voltage scope, support 15-160VDC Input, support 12-110VAC input. Large heat sink with mounting holes. Ultra-high-power control. support 5A current. Except the board inside a PWM speed control, can also support an external PWM signal input speed control, external PWM input requirements: level 3.5-12V VPP, the frequency of 1K-10KHZ, the duty ratio is 0% to 93%. in particular apply in MCH3 spindle speed control. when with external PLC control, a 2K resistor is used. A wide range of support motor. It can be used to control most of the DC motor in the market. As long as the DC resistance of the motor is > 2 Ohms DC resistance . The conversion rate is about 97%, and the power of the plate is different when the voltage is different. 160VDC,2A motor load, limit no more than 2W. This drive can't fit for the DC motor that DC resistance is <2 Ohm When the control board is equipped with DC Motor, following conditions must meet: current<5A, resistance>2R, Voltage <110V Equipped with a protection and better performance. The high power limiting resistance is adopted to reduce the heating of the whole module and improve the working stability. Specifications: Voltage input: 15-160VDC ,12-110VAC Max current:5A current Weight:135g Package Included: 1 x Motor Speed Controller

• DC MOTOR SPEED CONTROLLER -- drive 5V to 110V DC motor (within 5A) to adjust the speed of the DC motor. For DC water pump, for fan, for engraving machine spindle and other instruments and equipment, the speed of DC motor can be adjusted accurately.
• AC/DC INPUT -- It can support AC and DC input. There is no power supply polarity problem. DC supports 15-160VDC. input. AC supports 12-110VAC input; the maximum power supply is 110VAC, and it cannot be directly connected to 220V. It is recommended to use a power supply below 90V.
• PWM CONTROL -- Onboard PWM speed regulation, and also supports external PWM signal input to control speed regulation. The external PWM input requirements are: level 3.5-12V VPP, frequency 1K-5KHZ, and duty cycle 0%-93%.
• MOTOR SUPPORT -- Basically, it can drive and control most of the DC motors on the market. As long as the DC resistance of the motor is greater than 2 ohm DC motor. Especially suitable for MCH3 spindle control speed regulation. When equipped with an external PLC control, a 2K resistor should be connected in series.
• PLEASE PAY SPECIAL ATTENTION -- the conversion rate is about 97%, and the power consumption of the board itself is different when the voltage is different. When the motor load is 160VDC, 2A, the limit does not exceed 2W. This drive cannot adjust the speed of a DC motor with a DC resistance of less than 2 ohms.